Deprocessing Unpacked Equipment. - TM-55-1905-223-24-40219

TM 55-1905-223-24-4

4-5. Deprocessing Unpacked Equipment.

a. Remove protective caps, plugs, inserts, wrappings, and tape when inspection/inventory is completed. Inspect

piping openings for damage. Wipe off dirt, grease, or protective films at time of installation.

b. Remove chocks from resilient mounted components.

4-6. Operational Procedures.

a. Initial Setup Procedure. Includes operational checks and inspections that are not performed for a routine startup.

Direct support maintenance personnel will perform initial setup in accordance with the operator's manual, TM 55-

1905-223-10.

b. Normal Startup. Refer to the operator's manuals TM 55-1'905-223-10.

Shutdown Procedure (Usual or Unusual). Refer to the operator's manual, TM 55-1905-223t10.

Section III. INTERMEDIATE GENERAL SUPPORT PREVENTIVE

MAINTENANCE CHECKS AND SERVICES (PMCS)

There is no PMCS at the general support level. See Chapter 2, Section III.

Section IV. INTERMEDIATE GENERAL SUPPORT TROUBLESHOOTING

There is no troubleshooting at the general support level. See Chapter 2, Section IV.

4-2