Chapter 4. INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS

TM 55-1905-223-24-4

CHAPTER 4

INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS

Page

Repair Parts, Special Tools; Test, Measurement, and

Diagnostic Equipment (TMDE); and Support Equipment................................ ............................

Service Upon Receipt................................ ................................ ................................ ................

Intermediate General Support Preventive Maintenance

Checks and Services (PMCS). ................................ ................................ ................................ ..

Intermediate General Support Troubleshooting............................... ................................ ..........

Intermediate General Support Maintenance Procedures................................ ............................

Preparation for Storage or Shipment ................................ ................................ .........................

Section I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT AND DIAGNOSTIC

EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT

4-1. Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified Table of

Organization and Equipment (MTOE) applicable to your organization.

4-2. Special Tools, TMDE, and Support Equipment . Special tools; test, measurement, and diagnostic equipment;

and support equipment requirements are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM

55-1905-223-24P. These items are also listed in the Maintenance Allocation Chart (MAC), Appendix B of this manual.

4-3. Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL), TM 55-

1905-223-24P.

Section II. SERVICE UPON RECEIPT

4-4. Checking Unpacked Equipment.

a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the

damage in accordance with the instructions of DA Pam 738-750.

b. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in

accordance with the instructions of DA Pam 738-750.

Check to see whether the equipment has been modified.

4-1