 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 (c) Use a wire approximately .020 inches diameter as a feeler
by threading the wire down through the small hole so that
when the master cylinder is rotated in its threaded support,
the wire will be felt to contact the edge of the piston
cup. Rotate the master cylinder to its normal vertical
position and tighten the jam nut. Do not rotate cylinder
beyond where cup was felt with the wire to align cylinder
in vertical position. If the unit is threaded too far,
leakage my occur around the front of the piston during
the backing up cycle. Two grease fittings are provided
on actuator tube. Three shots every 1,000 miles, or at
the most every 6 months is sufficient.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals