 |
|||
|
|
|||
|
Page Title:
Figure 4-37. Scissors Shafts and Arm Rollers (Sheet 2 of 2). |
|
||
| ||||||||||
|
|
 TM 55-1730-228-13&P
4-31. SCISSORS, SCISSORS ARM ROLLERS AND SHAFTS - REPLACE (Continued)
4-31
Figure 4-37. Scissors Shafts and Arm Rollers (Sheet 2 of 2).
2 Remove retaining ring (2) and washers (3) on one end of affected shaft(s) (4).
3 Remove grease fitting(s) (5) from affected shaft(s) (4).
4 Install hardwood blocking between scissors sections to take tension off shafts.
5 Drive affected shaft (4) out of scissors from opposite side using a hammer and drift pin.
NOTE
Washers (6) will come out with shaft.
(c) To remove scissor arm rollers:
1 Remove nut (7) and washer (8) from camfollower (9).
2 Remove camfollower (9) from arm (10).
GO ON TO NEXT PAGE
4-104
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals