 |
|||
|
|
|||
|
Page Title:
Backing SPEMS Away From Work Area (Aft Position) |
|
||
| ||||||||||
|
|
 TM55-1730-228-13&P
(c) Raise the platform to approximately 14.5 feet (4.4 meters). The ladder may be adjusted to the correct
height as SPEMS nears the aircraft.
(d) Align the opening of the elevated SPEMS deck while slowly approaching the aircraft from approximately
10 feet (3 meters) away.
NOTE
For better visability, the SPEMS platform controller may be moved to the center guard rail position.
(e) Stop forward drive motion when SPEMS is centered and the platform is 8 to 12 inches (20 to 30 cm) away
from the aircraft.
(f) Lower Stabilizers.
(g) Check vertical alignment to aircraft. Adjust if necessary.
h) Traverse platform forward.
(i) Shutdown SPEMS.
(j) Unhook chains from deck extension guardrails.
(k) Extend deck extensions.
(1) Attach static discharge lines.
(2) Backing SPEMS Away From Work Area (Aft Position):
(a) Remove tools and materials from deck extensions.
(b) Disconnect static discharge lines.
(c) Retract both deck extensions
(d) Attach chains to guardrails.
(e) Start SPEMS and allow to idle for 15 minutes to warm up.
WARNING
Tools and obstructions on or around SPEMS could injure personnel and/or damage equipment.
(f) Traverse platform back.
(g) Raise stabilizers.
GO ON TO NEXT PAGE
2-31
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals