PLATFORM SAFETY SUMMARY

TM 55-1730-228-13&P

CAUTION

If the SPEMS is left in the raised position at the equipment for an extended period of time, check and

adjust platform elevation every 12 hours to avoid damage to the equipment from the platform due to lift

cylinder leak-down. Failure to do so may result in SPEMS damage.

CAUTION

Surface Conditions: The high torque and gradeability characteristics of the SPEMS are intended for travel

between overhead work locations only. Before raising the platform, it is essential that the SPEMS be on a

hard and level surface. Failure to do so may result in SPEMS damage.

2-8. PLATFORM SAFETY SUMMARY

2-8

A continued attitude of, and commitment to safety is essential for the proper and safe use of the SPEMS. Remember-

Any Equipment in Unsafe Hands Is Dangerous. Overhead safety depends largely on operator safety!

WARNING

The rated load capacity of the SPEMS, shown on one serial number plate and data plate MUST NOT be

exceeded under any circumstances, either raising, lowering or holding. Failure to do so may result in

severe personal injury.

WARNING

Never climb on the scissors mechanism. Use the platform ladders mounting or dismounting the SPEMS.

Failure to do so may result in severe personal injury.

WARNING

Be sure the area around the SPEMS is clear of personnel before operation. Failure to do so may result in

severe personal injury. Stop operation of SPEMS immediately if it is not functioning correctly. Failure to

do so may result in severe personal injury.

2-14