FEDERAL SUPPLY CODES FOR MANUFACTURERS

TM 55-1670-259-20

total quantity of parts required by converting the

specific manufacturer's model designation.

equipment quantity to a decimal factor by placing a

decimal point before the next to last digit of the num-

d. Unit of Measure (U/M). A two-character alpha-

b e r to indicate hundredths, and multiplying the

betic abbreviation indicating the amount or quantity

decimal factor by the parts quantity authorized in the

of the item upon which the allowances are based (e.g.,

51-100 allowance subcolumn. Example: authorized

FT, EA, PR).

allowance for 51-100 equipments is 40; for 150 equip-

ments, multiply 40 by 1.50 or 60 parts required.

e. Quantity Incorporated in Unit. Indicates the

quantity of the item used in the assembly. A "V"

(4) Subsequent changes to allowances will be

appearing in this column in lieu of a quantity in-

limited as follows: No change in the range of item is

dicates that a definite quantity cannot be indicated.

authorized. If additional items are considered neces-

sary, recommendation should be forwarded to U. S.

f. Fifteen-Day Organizational Maintenance Allow-

Army Aviation Systems Command for exception of

ante.

revision to the allowance list. Revisions to the range

of items authorized will be made by the U. S. Army

(1) The allowance column is divided into four

Aviation Systems Command based upon engineering

subcolumns. Indicated in each subcolumn, opposite

experience, demand data, or TAERS information.

the first appearance of each item, is the total quantity

of items authorized for the number of equipments

g. IIIustration. This column is divided as follows:

supported. Subsequent appearances of the same item

will have the letters "REF" in the allowance column.

(1) Figure number. Indicates the figure number of

Items authorized for use as required but not for initial

the illustration in which the item is shown.

stockage are identified with an asterisk in the allow-

ance column.

(2) Item number: Indicates the callout number to

reference the item in the illustration.

(2) The quantitative allowances for organizational

level of maintenance represents an initial prescribed

4. FEDERAL SUPPLY CODES FOR MANUFAC-

load for a 15-day period for the number of equipments

TURERS.

supported. Units and organizations authorized addi-

tional prescribed loads will multiply the number of

CODE

MANUFACTURER

prescribed loads, authorized by the quantity of repair

96906

Military Standards

parts reflected in the density column applicable to the

Promulgated by Standardization Division

number of items supported, to obtain the total quantity

D i r e c t orate of Logistic Services, DSA

of repair parts authorized.

Aeroquip Cap., Aircraft Division

99879

Elbeeco Plant, 1130 Maynard Rd.

(3) Organizational units providing maintenance for

Jackson, Michigan

more than 100 of these equipments shall determine the

C-2

Change 1